IDE-SATA01 is a Parallel ATA to Serial ATA Host mode Bridge Board featuring Marvell 88SA8040 Serial ATA bridge Controller.

IDE-SATA04 is a Parallel ATA to Serial ATA Host mode Bridge Board featuring JMicron JM20330B2 Serial ATA bridge Controller.

IDE-SATA01/04 is ideally suited for tailgate interface applications for converting Serial ATA device to ATA device. Both ATA and ATAPI modes are supported using the same firmware.

It allows SATA drive to be connected to ATA host controller. IDE-SATA01/04 provides the perfect solution for legacy ATA host controller to attach new SATA devices.

IDE-SATA01- Marvell 88SA8040

IDE-SATA04- JMicron JM20330B2

Serial ATA:
- Compliant with Serial ATA 1.0
- 48-bit sector addressing

Serial ATA Connector:
- Signal + Power Female Type Connector

Parallel ATA:
- Ultra ATA/133 Parallel Interface
- 48-bit sector addressing
- Jumper for selecting Mater and Slave

Parallel ATA Connector:
- Male IDC 2X20 pin Connector

Transfer Rate:
- Supports PIO and DMA modes
- Supports bus master DMA at 1.5Gbps burst rate

DC Power Connector:
- Mini 4-pin floppy type power connector

Jumper :
- Pin 1-2 : Slave Mode
- Pin 2-3 : Master Mode

Salve Mode	Master Mode

LEDs
- Power indicator LED, IDE Access LED and PHY Ready LED

Physical Dimensions:
- 3.97" x 1.00" (10.09cm x 2.54cm)
- Direct Connect Vertical type - 3.5" HDD Form Factor

MORE INFORMATION AVAILABLE AT Bridge Board