IDE-SATA07 is a Parallel ATA to Serial ATA Host mode Bridge Board featuring Marvell 88SA8052 Serial ATA bridge Controller.

IDE-SATA07 is ideally suited for tailgate interface applications for converting Serial ATA device into ATA device. Both ATA and ATAPI modes are supported using the same firmware.

 

 

Parallel ATA to Serial ATA Bridge Board:

  • Serial ATA:
    • Compliant with Serial ATA 1.0
    • 48-bit sector addressing
  • Serial ATA Connector:
    • Signal + Power (7+15 pin) Female Type Connector
  • Parallel ATA:
    • Ultra ATA/133 Parallel Interface
    • 48-bit sector addressing
    • Jumper for selecting Mater and Slave
  • Parallel ATA Connector:
    • Male IDC 2X20 pin Connector
  • Transfer Rate:
    • Supports PIO and DMA modes
    • Supports bus master DMA at 1.5Gbps burst rate
  • DC Power Connector:
    • IDE Big 4-pin power connector
  • LEDs
    • Power LED
    • SATA PHY Ready LED
    • Activity LED (Pin Header 2pin Pitch=2.54mm

  • 2.3 " x 1.00" (5.85cm x 2.54cm)
  • Direct Connect Vertical type
IOI Technology Corporation
Product Websites:
www.ioi.com.tw |www.ioiusb.com | www.ioi1394.com
OEM/ODM Welcome and DISTRIBUTORS Wanted
Email: sales@ioi.com.tw

MORE INFORMATION AVAILABLE AT IDE-SATA07

If you can't see this information, please link it. thanks