S2-ATAPIS50 is a SATA to ATAPI (Slim50) Bridge Board for converting standard ATAPI (fine-pitch 50-pin connector) slim ODD (Optical Disk Drive) into SATA slim ODD. It’s fully compatible with all kinds of slim ODDs, like CD-ROM, DVD-ROM, CD-RW and DVD-RW drives.

• SATA Interface:
  • One SATA Signal 7pin Latch Type Connector.
  • Serial ATA Generation 2 transfer rate of 3.0 Gbp/s.
  • SATA power save modes.
  • SATA hot-plug.
  • SATA II-standard Set Features for disabling device-initiated SATA power management.
• IDE (ATA/ATAPI) Interface:
  • Fine-pitch 50-pin connector for slim CD/DVD drive.
• AT Attachment with Packet Interface Extension (ATA/ATAPI-7) Compliant:
  • ATA/ATAPI PIO mode data transfer.
  • ATA/ATAPI UDMA data transfer rates of 16.7, 25, 33, 44, 66, 100, 133, and 150 MB/s.
  • ATA/ATAPI PACKET Command feature set which supports INF-8090i packet commands.
  • Tagged command queuing (maximum 32 entries).
  • ATA/ATAPI-7 streaming feature set.
  • ATA/ATAPI-7 Force Unit Access commands.
  • ATA/ATAPI 48-bit Address feature set.
• Power Connector:
  • FDD (Floppy Disk Drive) like mini 4-pin power connector.
• CD Audio connectors:
  • One 4-pin 2.54 pitch CD Audio connector.
  • One 4-pin 2.0 pitch CD Audio connector.
• Jumper for selecting 1.5Gbp/s or 3.0Gbp/s.
• Physical Dimensions: With the same height (1.25cm) as Slim ODD.
  • 10.3cm x 1.25cm (4" x 0.49")
  • Direct Connect Vertical type