| 
SATA-IDE03-S is a Serial ATA to Parallel
ATA Bridge Board featuring Marvell 88SA8040 Serial ATA bridge Controller.
SATA-IDE03-S is ideally suited for tailgate interface
applications for removable-media drives CD-ROM, CD-R, CD-RW, DVD-ROM,
DVD-RAM, tape drive, and hard disk drive.
Both ATA and ATAPI devices are supported using the
same firmware.
It allows IDE drives (Master or Slave) to be connected to Serial ATA
bus.
SATA-IDE03-S provides the perfect solution for data backup and transfering
of data between SATA host controller and IDE (ATA/ATAPI) devices.
SATA-IDE03-S comes with two different metal bracket
sizes. 
- SATA-IDE03-S-I: SCSI I 50pin Low Density Centronics
Connector Form Factor Bracket
- SATA-IDE03-S-II: SCSI II 50pin High Density Connector
Form Factor Bracket
- Serial ATA:
- Compliant with Serial ATA 1.0
- 48-bit sector addressing
- Transfer Rate:
- Supports PIO and DMA modes
- Supports bus master DMA at 1.5Gbps burst rate
- Serial ATA Connector:
- One External Port (Signal Plug Type II)
- Parallel ATA:
- PIO Mode 0, 1, 2
- Multiword DMA Mode 0 - 2
- Ultra DMA Mode 0 ~ 6 (UDMA 133)
- Supports 48-bit addressing for large hard drives
(>128GB).
- Parallel ATA Connector:
- Female IDC 2X20 pin Connector
- DC Power Connector:
- Mini 4-pin floppy type power connector
- Physical Dimensions:
- 2.36" x 1.26" (6.00cm x 3.20cm)
|
