U2-PSATA03S is an USB 2.0 to ATA & Serial ATA bridge board.
U2-PSATA03S is ideally suited for tailgate interface applications for two ATA/SATA devices. It allows ATA/SATA drives (Master and Slave) to be connected to USB 2.0 serial bus in a plug-and-play fashion.
U2-PSATA03S provides the perfect solution for data backup and transferring of data between computers using ATA/SATA drives.

USB 2.0 to ATA/SATA Bridge Board:

DC Power Connector

• DC Power Connector: with mini 4-pin Floppy Disk Drive power connector

IDE Interface

• IDE (ATA) Interface: Male IDC 2X20 Connector
• Both ATA and ATAPI devices are supported using the same firmware.
• Complies with T13's ATA/ATAPI-6 Draft Specification:

• PIO Mode 0 ~ 4
• Multi-Word DMA Mode 0 ~ 2
• Ultra DMA Mode 0 ~ 5
• Supports 48-bit addressing for large hard drives (>128GB).

Serial ATA Port

• Complies with Gen1i and Gen1m of Serial ATA II Electronical Specification 1.0
• Serial ATA Bus Transfer Rate: 1.5 Gbps
• Support hot-plug & hot-swap feature of Serial ATA to USB.
• Serial ATA port: One Signal Plug Type (7pin) Connectors

USB 2.0 Interface

• USB 2.0 Interface: One USB B-Type connector
• USB Bus Transfer Rate: High Speed (480 Mbit) And Full Speed (12 Mbit)
• USB Bus Power: Self Powered Mode Operation

LEDs

• Power indicator LED and ATA/SATA Access LED

Form Factor

• SCSI I 50pin Low Density Centronics Connector Form Factor
  (Fit to most standard SCSI enclosure)

Physical Dimensions

• Physical Dimensions: 2.97" x 1.34" (7.54cm x 3.40cm)

• Two IDE (ATA/ATAPI) drives.
• One IDE (ATA/ATAPI) and one Serial ATA drives.
  

• Desktop PC: with either a built-in USB (1.0 or 2.0) controller or an USB (1.0 or 2.0) to PCI Host Adapter equipped with a external USB port.
• Laptop PC: with either a built-in USB (1.0 or 2.0) controller or an USB (1.0 or 2.0) to CardBus PC Card equipped with a external USB port.

• Windows and Mac

• Windows 98SE, ME
• Windows 2000, XP
• MacOS 9.1 or higher
• Driver Requirements
  • No driver installation for Windows ME, 2000, XP and Mac OS
  • Driver available for Window 98 SE
    

• U2-PSATA03S bridge board.
• A-to-B type USB 2.0 Cable (1.0m length).
• Ultra DMA100 Cable 18 inch for two devices (Master & Slave).
• SATA 7pin to SATA 7pin cable for SATA HDD.
• SATA 15pin female -to- IDE big 4pin male power connector cable.
• Y-Shape (one IDE big 4pin male to one floppy drive like mini 4pin and one IDE big 4pin female) DC Power Cable (Red, Black, Black, Yellow)
• Overview and User's Guide

MORE INFORMATION AVAILABLE AT U2-PSATA03S