• SATA-IDE03-S support one IDE (ATA/ATAPI) device.

SATA-IDE03-S is a Serial ATA to Parallel ATA Bridge Board featuring Marvell 88SA8040 Serial ATA bridge Controller.

SATA-IDE03-S is ideally suited for tailgate interface applications for removable-media drives CD-ROM, CD-R, CD-RW, DVD-ROM, DVD-RAM, tape drive, and hard disk drive.

Both ATA and ATAPI devices are supported using the same firmware. It allows IDE drives (Master or Slave) to be connected to Serial ATA bus. SATA-IDE03-S provides the perfect solution for data backup and transfering of data between SATA host controller and IDE (ATA/ATAPI) devices.

SATA-IDE03-S comes with two different metal bracket sizes. See the following demo pictures:

SATA-IDE03-S-I:
SCSI I Connector Form Factor Bracket

SATA-IDE03-S-II:
SCSI II Connector Form Factor Bracket

Serial ATA to Parallel ATA Bridge Board:

• Serial ATA:
  • Compliant with Serial ATA 1.0
  • 48-bit sector addressing
• Transfer Rate:
  • Supports PIO and DMA modes
  • Supports bus master DMA at 1.5Gbps burst rate
• Serial ATA Connector:
  • One External Port (Signal Plug Type II)
• Parallel ATA:
  • Ultra ATA/133 Parallel Interface
  • 48-bit sector addressing
• Parallel ATA Connector:
  • Female IDC 2X20 pin Connector
• DC Power Connector:
  • Mini 4-pin floppy type power connector
• Form Factor:
  • SCSI I 50pin Low Density Centronics Connector Form Factor. (Fit to most standard SCSI enclosure)

• 2.36" x 1.26" (6.00cm x 3.20cm)

• Windows 98
• Windows NT 4.0
• Windows 2000
• Windows Me
• Windows XP
• Linux