Highlights
  • Provides eSATA , FireWire 800 & USB 2.0 Interface
  • Support two SATA devices
  • Hardware RAID engine supporting RAID 0, 1,and spanning over USB, FireWire and eSATA
  • Advanced encryption features such as AES-XTS and AES-CBC
Introduction

UFS-DSATA210 is eSATA, FireWire800 (IEEE 1394b) & USB 2.0 ComBo to Dual SATA RAID Bridge Board with Encryption.

UFS-DSATA210 is a selectable hardware RAID Bridge Board for two SATA HDDs. A true hardware solution UFS-DSATA210 requires no software to be installed on your machine.

It provides 4 hardware RAID mode:

  • RAID 0 (Striping): for two disks with same capacity.
  • RAID 1 (Mirroring): for two disks with same capacity.
  • BIG (Spanning): for two disks with different capacity.
  • PM (JBOD): Non-RAID.

RAID 0 (Striping):
By striping technique, UFS-DSATA210 integrates two HDDs into a high performance drive.

BIG (Spanning):
By spanning technique, UFS-DSATA210 integrates two HDDs into a big drive.

RAID 1 (Mirroring):
By mirroring technique, UFS-DSATA210 maintains data in two disk drives simultaneously and securely. If one drive fails, UFS-DSATA210 automatically switches operations to the functional drive and alert the failure. Once a new HDD is installed to replace the defective drive, the UFS-DSATA210 will automatic rebuild the entire HDD image in the background, while providing the un-interrupt data connection to the system.

Hardware cipher engine supporting real-time 128-bit and 256-bit AES encryption/decryption over USB, FireWire and eSATA
Technical Specifications
Host Interface
  • USB 2.0:
    • USB 2.0 Port: One USB Mini B-Type connector
    • USB Bus Transfer Rate: High Speed (480 Mbit) And Full Speed (12 Mbit)
    • USB Bus Power: Self Powered Mode Operation
  • FireWire:
    • FireWire Port: Two Bilingual (IEEE 1394b) Connectors
    • 1394b PHY: Ti's TSB81BA3E
    • 1394 Bus Transfer Rate: 100/200/400/800 Mbps
    • IEEE 1394 Bus Power: It is a Self-powered bridge board. It do not take power from the IEEE 1394 Bus but will provide DC 11.5V power to the IEEE 1394 Bus
  • eSATA:
    • eSATA Singal 7pin Connector
    • supports the Gen2m interface
RAID

Hardware RAID engine supporting RAID 0, 1, spanning, JBOD over USB, FireWire and eSATA. eSATA supports only one SATA HDD for JBOD mode in Windows XP.

  • Hardware accelerated RAID rebuild
  • Online rebuild rates up to single disk speed
  • Support for load-balancing rebuilds versus host activity

Encryption

Hardware cipher engine supporting real-time 128-bit and 256-bit AES encryption/decryption over USB, FireWire and eSATA. eSATA supports only one SATA HDD encryption for JBOD mode.

  • Support for 128-bit and 256-bit keys
  • Support for AES-ECB and AESCBC algorithms
  • Support for AES-XTS as defined by IEEE P1619
  • Host software and driver supplied for password application for PC and Mac
Device Interface
  • SATA Transfer Rate: 300Mbytes/s
  • SATA Drive Port: Two SATA Signal 7pin Latch Type Connector
  • Supports storage with more than 2 TB per Volume
DC Power Connector
  • Mini 4-pin Floppy Disk Drive like power connector
  • Supply DC 5V&12V power
  • It is a Self-powered bridge board and need DC 5V power.
Environmental
Condition
  • Operating Temperature: 10℃~40℃ (50℉~104℉)
  • Relative Humidity: 10%~85% Non-condensing
Physical Dimensions
  • SCSI I 50pin Low Density Centronics Connector Form Factor (Fit to most standard SCSI enclosure)
  • 83.3(W) x 21.56(H) x 61.5(D)mm
Pin Header
  • Power LED
  • HDD Active LED
  • 1394/USB/eSATA Active LED
Hardware Requirements
  • Desktop PC / Laptop PC: with either eSATA, USB or FireWire (IEEE 1394) ports.
Kit includes
  • UFS-DSATA210 bridge board.
  • CB-00072--- Y-Shape DC Power Cable (Red, Black, Black, Yellow) with three power connectors
    one FDD like mini 4pin, one IDE big 4pin male plug and one IDE big 4pin female plug
  • User's Manual
  • CD title (Encryption Utility)